Media Wall Installers in Great Neck

median year homes were built

1952

median year homes were built

built in 2000 or later

10.9%

built in 2000 or later

built before 1960

66.7%

built before 1960

single-family homes

70.9%

single-family homes

in buildings with 5+ units

24.6%

in buildings with 5+ units

mobile homes

1.3%

mobile homes

Source: U.S. Census Bureau, ACS 2024 5-year, Great Neck village (tables B25035, B25034, B25024)

Common wall types

Wood-frame walls with drywall

Where: Postwar Cape Cod, ranch and split-level houses in Great Neck Estates and nearby villages.

Mounting: Studs are typically 16 inches on center. Lag into at least two studs with 5/16" lags; confirm with a stud finder, since older houses can have irregular spacing.

Finished basement walls

Where: Basement dens and rec rooms in Nassau and Suffolk houses.

Mounting: Check for moisture first. Framed or furred walls allow lags into studs; bare block or poured concrete needs 1/4" concrete screws or sleeve anchors.

Co-op and condo buildings

Where: Mid-rise co-op and condo apartments around Great Neck Plaza.

Mounting: Concrete and masonry walls need hammer-drill anchors; metal-stud partitions need snap toggles. Boards usually require approval and a COI.

Plaster and masonry in older estates

Where: Older Colonial, Tudor and Gold Coast houses in Kings Point and Great Neck Estates.

Mounting: Plaster may sit on masonry or lath; locate backing before drilling.

Tips before you mount

• Frame houses are the norm here: lag the mount into studs with 5/16" lag bolts about 2.5" to 3" long, hitting at least two studs; a full-motion arm needs more support than a fixed mount.
• Basements on Long Island often have moisture from a high water table, so check for stains or white mineral deposits before mounting, and use framed furring walls with corrosion-resistant fasteners rather than drilling directly into damp block.
• Great Neck Plaza co-ops and condos: ask the board or managing agent for alteration rules and a COI requirement before scheduling.
• Waterfront houses in Kings Point and Great Neck Estates see salt air and humidity; use weather-rated TVs and corrosion-resistant hardware outdoors.
• Over a fireplace: check the TV maker's heat limit and measure the surround temperature while the fireplace is running; a deep mantel or tilting mount reduces heat exposure.
• Hiding wires: a regular TV power cord may not be concealed in the wall (NEC 400.12), so use an in-wall rated power kit and CL2 or CL3 low-voltage cable; cable fished through a finished-basement or attic wall is usually easy in these frame houses.