Media Wall Installers in Eastchester

median year homes were built

1952

median year homes were built

built in 2000 or later

4.5%

built in 2000 or later

built before 1960

71%

built before 1960

single-family homes

54.2%

single-family homes

in buildings with 5+ units

33.6%

in buildings with 5+ units

mobile homes

0.4%

mobile homes

Source: U.S. Census Bureau, ACS 2024 5-year, Eastchester CDP (tables B25035, B25034, B25024)

Common wall types

Plaster walls in 1920s-era Tudor and Colonial houses

Where: Single-family streets across Eastchester, Tuckahoe and Bronxville, where Tudor-style houses are common.

Mounting: Plaster over wood or metal lath is hard and brittle. Find the studs, pre-drill slowly, and lag a mount into studs; use snap toggles only for light loads between studs.

Cape Cod and postwar frame houses

Where: Neighborhoods such as Wilmot Manor and other mid-century streets in the town.

Mounting: Drywall over wood studs, usually 16 in on center. Lag into at least two studs with 5/16 in lag bolts.

Co-op and condo apartment buildings

Where: Mid-rise buildings in Bronxville village and along Tuckahoe's rail corridor.

Mounting: Walls are often plaster over masonry or metal-stud partitions. Use concrete screws or sleeve anchors in masonry and snap toggles or added blocking in metal studs; most boards require approval first.

Stone and block basement walls

Where: Basements of older Westchester houses used for media rooms.

Mounting: Hammer-drill with 1/4 in concrete screws or 3/8 in sleeve anchors, anchoring into solid block face shells or stone rather than loose mortar; address dampness before framing over it.

Tips before you mount

• Tudor and Colonial houses from the 1920s often have plaster on rock or wood lath: confirm studs with a pilot hole, since lath can fool stud finders, and expect slightly irregular stud spacing.
• For a media wall over a fireplace in an older house, check the firebox clearances and flue location first; masonry surrounds need masonry anchors, and a TV mounted high above a working fireplace sits in a heat plume.
• Co-ops and condos in Bronxville and Tuckahoe usually require a written alteration request and a certificate of insurance (COI) from any installer before drilling; ask the managing agent about restrictions on drilling into slab ceilings and exterior walls.
• Basement theaters: Westchester basements can see seasonal moisture. Mount to the block or concrete only after any dampness is solved, and use a vapor-aware stud frame if building a wall in front of foundation masonry.
• Cape Cods and small postwar houses often have knee walls and sloped upper-floor ceilings; confirm that a bedroom TV mount lands on full-height studs, not a knee-wall plate.
• Running cable inside plaster walls usually means notching through lath and blocking; surface raceways are a neater option on finished plaster. Use CL2 or CL3 rated cable and an in-wall rated power kit, since NEC 400.12 does not permit a plain power cord inside a wall.