Media Wall Installers in Altamonte Springs

median year homes were built

1983

median year homes were built

built in 2000 or later

15.9%

built in 2000 or later

built before 1960

3.7%

built before 1960

single-family homes

35.1%

single-family homes

in buildings with 5+ units

50.4%

in buildings with 5+ units

mobile homes

0.1%

mobile homes

Source: U.S. Census Bureau, ACS 2024 5-year, Altamonte Springs city (tables B25035, B25034, B25024)

Common wall types

Block and stucco single-family homes

Where: 1970s and 1980s subdivisions including Sanlando Springs.

Mounting: Block exteriors and drywall interiors; use masonry anchors in block and lags into studs.

Garden-style condo walls

Where: Condo communities along the I-4 corridor.

Mounting: Wood or metal studs depending on the building; use toggles or blocking and follow association rules.

Mid-rise and townhome construction

Where: Townhomes and mid-rise buildings near the Altamonte Mall area.

Mounting: Shared party walls in townhomes; keep fasteners short and confirm HOA rules.

Wood-frame interior partitions

Where: Interior walls in most houses and townhomes.

Mounting: Studs about 16" on center; lags for TV mounts, toggles for metal studs.

Tips before you mount

• Because many homes date to the 1970s and 1980s, check older electrical and cable locations before planning a recessed power and cable pass-through.
• Condo communities across the city commonly require board approval and a COI; ask management for the contractor rules before scheduling.
• Condo living-room walls may be wood studs while bath and kitchen walls differ; locate framing with a stud finder before choosing anchors.
• Townhomes share a party wall; use short fasteners and confirm HOA rules before drilling the shared wall.
• Screened porches and patios near Central Florida lakes see humidity and summer storms; use an outdoor-rated TV, stainless hardware and surge protection.
• Block and stucco ranches: use 1/4" masonry screws or sleeve anchors into the block, and keep anchors out of mortar joints where possible.
• Wiring: use an in-wall rated power kit and CL2/CL3 cable; where the wall is block, use surface raceway or an attic route.