Media Wall Installers in Ocala

median year homes were built

1986

median year homes were built

built in 2000 or later

33.1%

built in 2000 or later

built before 1960

10%

built before 1960

single-family homes

55.4%

single-family homes

in buildings with 5+ units

32.4%

in buildings with 5+ units

mobile homes

5.8%

mobile homes

Source: U.S. Census Bureau, ACS 2024 1-year, Ocala, FL (tables B25035, B25034, B25024)

Common wall types

Concrete block and stucco exterior walls

Where: New and recent subdivision houses, for example in the Silver Springs Shores area.

Mounting: Builders there advertise concrete block and stucco construction. Inside, treat exterior walls as masonry: use 1/4" concrete screws or 3/8" sleeve anchors in the block face, not in the drywall or furring.

Early 20th-century wood-frame houses

Where: Ocala Historic District, built roughly 1880-1930 and covering about 220 historic buildings.

Mounting: Older framing and plaster or thick wall finishes are possible. Find studs first, pre-drill slowly, and avoid heavy loads on plaster alone.

Wood-stud interior partitions

Where: Interior walls of most houses and townhomes across the city.

Mounting: Studs are typically 16" on center; heavy or full-motion mounts go into at least two studs.

Apartment and condo walls

Where: The roughly one-third of homes in buildings with 5 or more units.

Mounting: Metal studs and demising walls are common; snap toggles rated for the load or wood blocking added behind the drywall work better than plain anchors.

Tips before you mount

• Lag the mount into at least two studs, usually 16" on center, with 5/16" lag bolts; an articulating arm leverages far more weight on the wall than a fixed mount.
• Block exterior walls: hammer drill with a carbide masonry bit, keep anchors out of mortar joints where possible and out of the hollow cores unless the anchor is rated for hollow block.
• In historic-district houses, check for plaster and thicker walls before drilling; a stud finder plus a small pilot hole shows what you are drilling into.
• Florida humidity and afternoon storms: if the TV goes on a lanai or covered porch, use an outdoor-rated TV, stainless fasteners and sealed cable pass-throughs.
• Hiding wires: NEC 400.12 does not permit a standard TV power cord inside a wall cavity, so in-wall power needs a code-rated recessed outlet kit, while HDMI and speaker runs use CL2 or CL3 rated cable.
• Apartments and condos: confirm what the lease or association allows for drilling and get the installer's certificate of insurance (COI) if the building requires one.