Media Wall Installers in San Diego

median year homes were built

1980

median year homes were built

built in 2000 or later

22.2%

built in 2000 or later

built before 1960

18.5%

built before 1960

single-family homes

52.7%

single-family homes

in buildings with 5+ units

38.2%

in buildings with 5+ units

mobile homes

0.8%

mobile homes

Source: U.S. Census Bureau, ACS 2024 1-year, San Diego, CA (tables B25035, B25034, B25024)

Common wall types

Craftsman bungalows

Where: North Park, Hillcrest, Mission Hills, Normal Heights and Kensington, which became prominent around 1907.

Mounting: Early-century walls are plaster or thin drywall on irregular studs; locate studs and lag in, with toggles only between studs.

Spanish Revival stucco homes

Where: Point Loma, North Park and Mission Hills.

Mounting: Thick stucco and plaster interiors; use stud lags, and masonry anchors where a wall is solid.

Downtown high-rise condos

Where: Little Italy and downtown, for example La Vita (24 floors, completed 2004) and Luma (24 stories).

Mounting: Concrete anchors with a hammer drill and surface raceways; HOA approval and a COI are typical.

Postwar stucco tract homes

Where: Neighborhoods such as Clairemont and east San Diego.

Mounting: Drywall on studs at 16 inches on center; standard stud mounting.

Tips before you mount

• Mission Hills Historic District holds 174 homes; interior mounting is normally fine, but ask about preservation rules before altering visible exteriors or cable entries.
• Craftsman plaster in North Park and Hillcrest: pilot-drill slowly, lag into a stud, and avoid anchors in bare plaster for arms.
• Seismic: anchor into studs or concrete and strap consoles; San Diego sits in a region with several active faults.
• Marine layer and salt air near the coast: choose stainless fasteners and sealed penetrations for patio TVs.
• Little Italy and downtown towers: expect HOA move-in and work-hour rules and a COI naming the association before drilling concrete.
• Brush-edge canyons: Santa Ana winds raise dust and fire risk, so cover or bring in outdoor TVs when warnings are posted.
• In-wall runs: use an in-wall rated recessed power kit instead of routing a regular TV cord through the wall (NEC 400.12), with CL2/CL3 rated cable for HDMI and speakers.