TV bias-light LED controller (open hardware)
A small board that drives an addressable LED strip behind a wall-mounted TV ("bias lighting"). It is powered from USB-C and runs WLED or ESPHome. Designed with KiCad. The full KiCad project is free to download, modify and manufacture.
What's on the board
- ESP32-C3-WROOM-02 (Wi-Fi + BLE). Native USB, so it flashes over the same USB-C port.
- USB-C 5 V input (5.1 kΩ CC resistors), PTC fuse and a Schottky diode that stops back-feed.
- Optional 5 V screw terminal for long strips (power injection).
- 74AHCT1G125 level shifter (3.3 V → 5 V data), 330 Ω series resistor and a 470 µF bulk capacitor.
- JST-XH 3-pin strip connector (+5V / DIN / GND), BOOT and RESET buttons, status LED.
- 80 × 50 mm, 2 layers, 4 × M3 holes. Hand-solderable 0805 / SOT-23 parts.
Download
- KiCad project, schematic PDF, BOM, Gerbers and ESPHome config: github.com/getmediawall/tv-bias-light-controller
- Licence: CERN-OHL-P-2.0 (hardware), MIT (firmware config)
Plan the TV wall around it
Bias lighting works best when the TV sits at the right height and distance. To plan the whole wall to scale (TV size, slat panels, fireplace, console), use the free Design Your Wall planner.
Design prepared with AI assistance and checked with KiCad's electrical (ERC) and design-rule (DRC) checks: 0 errors. Typical values only; follow the data sheets of your parts and strip.