Media Wall Installers in Atlanta

median year homes were built

1993

median year homes were built

built in 2000 or later

44.6%

built in 2000 or later

built before 1960

23.5%

built before 1960

single-family homes

40.3%

single-family homes

in buildings with 5+ units

53.5%

in buildings with 5+ units

mobile homes

0.4%

mobile homes

Source: U.S. Census Bureau, ACS 2024 1-year, Atlanta, GA (tables B25035, B25034, B25024)

Common wall types

Victorian and Craftsman wood-frame houses

Where: Inman Park (planned in 1890), Grant Park (Victorian, Queen Anne and Craftsman houses) and similar intown districts.

Mounting: Older houses may have plaster or lath over framing; find studs first, pre-drill, and use toggle bolts only where framing is not available.

1920s bungalows

Where: Virginia-Highland and Home Park.

Mounting: Bungalows are usually wood-framed; lag mounts into studs, and check fireplace walls for heat and masonry.

High-rise condo and apartment walls

Where: Midtown towers.

Mounting: Concrete slabs and metal-stud partitions are typical: concrete anchors in structural walls, snap toggles in drywall, and surface raceways for cables.

Basement and foundation walls

Where: Hillier intown lots with finished basements.

Mounting: Confirm whether the wall is framed or furred over concrete before choosing anchors.

Tips before you mount

• Lag the mount into at least two studs, usually 16" on center, with 5/16" lag bolts; an articulating arm leverages far more weight on the wall than a fixed mount.
• Historic district houses: some neighborhoods have design review for exterior changes, so keep outdoor cable and mount work to the interior or check the rules first.
• Midtown condos: associations commonly require written approval for drilling and a contractor COI; ask for the rules before scheduling work.
• Georgia summers are hot and humid; outdoor TVs on porches need an outdoor-rated unit with corrosion-resistant hardware.
• Hiding wires: NEC 400.12 does not permit a standard TV power cord inside a wall cavity, so in-wall power needs a code-rated recessed outlet kit, while HDMI and speaker runs use CL2 or CL3 rated cable.
• In concrete walls use a hammer drill with 1/4" concrete screws or 3/8" sleeve anchors, and avoid rebar and embedded conduit by scanning first.